無錫市ag环亚娱乐平台干燥設備有限公司主營︰环亚APP下载熱風爐|ag88环亚娱乐燃氣熱風爐|直接式环亚APP下载熱風爐
當前位置 -> 熱風爐首頁熱風爐知識熱風爐安裝知識及產排污問題 發布時間︰(2018/11/29)關鍵詞︰熱風爐

熱風爐安裝知識及產排污問題

 

對于目前市場來說,燃氣是一種非︰媒諛芑繁,並且效率高,但是要讓更好使用,需要注意安裝問題。因為,再好安裝到位,正確的安裝好,那麼在使用的時候想完美的使用也是不可能的。的安裝︰在安裝前需要有一定的方案布置,確定房的位置,房的大。 褂蟹康母叨鵲鵲,因為熱風爐都是用來提供熱能的,所以熱風爐房的溫度是非︰玫,所以安裝好的熱風爐要留有充分的過道,保證通風還有行人的經過。並且最好選擇在行人經過比較少的位置。

For the current market, gas-fired hot stove is a very good hot stove energy-saving and environmental protection, and high efficiency, but to make the hot stove better use, we need to pay attention to the installation of hot stoves. Because, no matter how good the gas hot-blast stove is, if it is not installed in place and installed correctly, it is impossible to use it perfectly when using it. Installation of hot stove: 

Before installing the hot blast stove, we need to have a certain plan layout, determine the location of the hot blast stove room, the size of the hot blast stove room, and the height of the hot blast stove room, etc. Because the hot blast stove is used to provide heat energy, so the temperature of the hot blast stove room is very good, so the installed hot blast stove should have sufficient passageway to ensure the passage through. The wind and the passing of pedestrians. And it's better to choose a place where pedestrians pass less.

在接下來的安裝步奏中還要注意到的問題就是通風,因為燃氣熱風爐在使用的過程中會產生大量的油煙,即使每個燃氣熱風爐都有專門的排煙設施,但是在安裝的時候依舊要注意通風的問題。注意通風有兩個好處,第一就是有利于煙霧的排放,第二就是能夠保持熱風爐房內的溫度,使溫度置之于過高,使人在其中感覺不舒服。

In the next step of installation, we should also pay attention to the problem of ventilation, because the use of gas hot stoves will produce a large number of fumes, even if each gas hot stove has a special smoke exhaust facilities, but still pay attention to the problem of ventilation during installation. Note that ventilation has two advantages: first, it is conducive to smoke emissions; second, it can keep the temperature in the hot stove room, so that the temperature is too high, making people feel uncomfortable in it.

熱風爐的排污︰

Discharge of hot stove:

當燃氣熱風爐使用一段時間之後,环亚ag旗舰厅需要定期的去進行排污工作,在排污期間,有哪些步驟呢,环亚ag旗舰厅需要注意哪些呢,下面來看下︰

When the gas hot blast stove is used for a period of time, we need to regularly carry out the work of sewage discharge. During the period of sewage discharge, what steps do we need to pay attention to?

1、開啟定期排污總閥;

1. Open the regular sewage discharge main valve;

2、先開一次閥,再緩慢開啟二次閥;

2. Open the second valve slowly after opening the first valve.

3、排污完畢後,先關二次閥,後關一次閥;排污應緩慢進行,防止水沖擊,如管道發生嚴重振動,應停止排污,待故障消除後再進行排污;

3. After the sewage is discharged, the secondary valve should be shut down first, and then the primary valve should be shut down. The sewage should be discharged slowly to prevent water impact. If the pipeline has serious vibration, the sewage should be stopped and the sewage should be discharged after the fault is eliminated.

4、在排污過程中,如熱風爐發生事故,應立即停止排污,但汽包水位過高和汽水共騰除外;

4. In the process of sewage discharge, if an accident occurs in the hot blast stove, the sewage discharge shall be stopped immediately, except for the excessive water level of the drum and the co-evaporation of steam and water.

5、禁止兩台熱風爐同時進行排污。

5. It is forbidden to discharge pollutants simultaneously from two hot stoves.

燃氣熱風爐軟化水設備原水由進水口進入控制閥,從閥芯的上部經閥體,並由頂部進入罐內。然後,向下穿過樹脂層,成為軟化水,經下布水器返回中心管,向上至閥體,經閥芯後從軟化水設備出水口排出。軟化水設備原水由進水口進入控制閥,經閥芯進入射嘴的進口,並快速流向射嘴出口,產生負壓,從而將鹽罐內的鹽水從吸鹽口吸入閥體,進入罐體的頂部。這樣整個的燃氣熱風爐排污步驟就結束了,环亚ag旗舰厅在後期處理時,也要注意排污期間出現的問題,及時的去進行解決,做好整體的使用。

The raw water of softening water equipment of gas hot blast stove enters the control valve from the inlet, passes through the valve body from the upper part of the valve core, and enters the tank from the top. Then, it passes down through the resin layer to become softening water, returns to the central pipe through the lower water distributor, goes up to the valve body, and discharges from the outlet of the softening water equipment through the valve core. The raw water of the softening water equipment enters the control valve from the intake port, enters the nozzle through the valve core, and flows rapidly to the nozzle outlet to generate negative pressure, thus brine in the salt tank is sucked into the valve body from the salt suction port and enters the top of the tank body. In this way, the whole process of gas hot blast stove drainage is over. We should also pay attention to the problems during the drainage period, solve them in time, and make good use of the whole.



版權所有@轉載請注明︰http://www.sitetekk.com/shownews.asp?id=353

本站網址︰http://www.sitetekk.com 來源︰聯營熱風爐  瀏覽次數︰187 
相關閱讀︰客戶購買工業熱風爐廠要這樣。︵約郾/a> | 廠家總結間接式燃氣熱風爐知識【新手必讀】 | 你知道熱風爐的熱量單位是什麼嗎?

版權所有︰無錫市ag环亚娱乐平台干燥設備有限公司主營︰熱風爐    電話︰0510-83955910    傳真︰0510-83051522    技術支持︰易商科技